Scag Power Equipment GC-STWC-CS61V Instruções de Operação descarregar pdf (Página 34)

Section 7

7.2 LUBRICATION - GREASE FITTING LUBRICATION CHART

(SEE FIGURE 7-1)

LUBRICATION NO. OF

LOCATION INTERVAL LUBRICANT PLACES

1 Caster Wheel Pivot * 500 Hours/Yearly Chassis Grease 2

2 Caster Wheel Bearings 100 Hours/Bi-Weekly Chassis Grease 2

3 Brake Actuator 200 Hours/Monthly Chassis Grease 2

4 Cutter Deck Bellcranks 100 Hours/Bi-Weekly Chassis Grease 4

5 Cutter Deck Pusharms 100 Hours/Bi-Weekly Chassis Grease 2

6 Control Pivot 100 Hours/Bi-Weekly Chassis Grease 2

7 Cutter Deck Spindle 40 Hours/Weekly +Lithium MP White Grease 2125 3

8 Brake Handle 200 Hours/Monthly Chassis Grease 1

* PROCEDURE: Remove grease cap, part number 481559. Remove plug, part number 482028-01, and install

grease zerk. Apply grease to the fitting until new grease appears at the top of the caster extension. Remove the

grease zerk and reinstall the plug. Reinstall the grease cap. Special tool, part number 47007, is recommended for

use in the installation of the grease cap.

+ Compatible Greases: Mobilix #2 found at Mobil Service Stations

Shell Alvania #2 found at Shell Service Stations

Lidok EP #2 found at industrial shops

MAINTENANCE CHART - RECOMMENDED SERVICE INTERVALS (CONT'D)

HOURS

Break-In 8 40 100 200 500 Procedure Comments

(First 10)

X Apply grease to fittings See paragraph 7.2

X Check hardware for tightness

X Change engine oil filter See paragraph 7.4

X Check hydraulic oil level See paragraph 7.3

X Replace engine fuel filter See paragraph 7.5

X Drain hydraulic system and See paragraph 7.3

replace hydraulic oil Use SAE 20W50

Motor Oil

X Replace hydraulic oil filter See paragraph 7.3

X Adjust electric PTO clutch See Scag Dealer

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 117 118

Sem comentários

Scag Power Equipment GC-STWC-CS61V Instruções de Operação Página 34